Requirements : iPAQ H5100 Series
Overview : This SoftPaq contains an "execute in place" (XIP) Cab file that replaces the "Miscellaneous OEM" region of the ROM Image for the listed handheld model. This is a permanent update to the flash ROM.
Installation Instructions :
1. Download the SoftPaq .EXE file to a directory on your hard drive.
2. Establish an Activesync connection between the iPAQ Pocket PC and
host PC using either a USB or Serial connection.
3. Execute the downloaded file and follow the on-screen instructions.
INSTALLATION NOTES:
1. If the Regional Settings are changed to any language other than the
default language of the handheld, the Firmware update will not
complete and generate the following error message: "This update is
language specific. Please visit the HP website to verify that you
have downloaded the correct update.
2. IMPORTANT: Please observe the following restrictions:
- Do not enable the handheld password feature during the update
process.
- Do not attempt to Power Off or restart the handheld while the
update is in progress.
- Do not enable “Show information when device is turned on”
feature during the update process. To disable this feature,
click “Owner” on the Today screen and uncheck the box at the
bottom of the page, then click the Notes tab at the bottom of
the page and uncheck “Show information when device is turned
on,” which is located at the bottom of the page.
- After applying a firmware (ROM) update, do not attempt to
restore a backup that was made before the ROM update was
installed.
3. IMPORTANT: Disable the Standby and Hibernation modes on the host PC.
If Standby or Hibernation mode is activated during the upgrade
process, a critical error may occur.
4. IMPORTANT: Plan enough time to complete the update process. The
total time to perform the firmware update is estimated to be as
follows:
- For USB connection - 10 minutes
- For Serial connection - 20 minutes
5. IMPORTANT: Do not interact with the handheld or remove it from
AC power or from the cradle/cable once the hourglass appears on
the handheld and the actual firmware update has started.
6. If an error message is displayed during the update process, follow
any available instructions to correct the condition and start the
update again.
7. The update process can be performed while connected to a host PC
either as a Guest or with an established partnership.
NOTE: This XIP firmware update does not change the ROM version. To confirm
that the XIP firmware update was successful, check the versions of the
individual components by clicking Start, Settings, System, and Asset Viewer
or by opening each individual application and checking the version number.
If the update was successful, applications will show version numbers,
as follows:
- Bluetooth Driver Version 1.4.1.60
- iPAQ Backup Software Version 1.1.0.6
- IPSM Version 3614.3212
- iTask Version 2.16
- iPAQ Image Viewer version 2.12b
Download:
http://rapidshare.com/files/89239190/iPAQ_H5100_Series_Firmware_Update_WM2003_v1.00.11_English.rarPlease Post Your Suggestions.
No comments:
Post a Comment